Linn AV Personal Handset - Manual (Page 23)

programming the AV Personal Handset
19
p r o g r a m m i n g t h e A V P e r s o n a l H a n d s e t
In addition to providing all the functions necessary to control the AV 5103
System Controller and any other Linn equipment in your system, the
Personal Handset can learn commands from the infra-red handsets for other
equipment you may own. This allows you to program your Linn Personal
Handset so that it is the only handset you need in your system, allowing you
to control all your hi-fi, audio, and video components from a single
convenient keypad.
The Personal Handset provides two programmable groups of keys: the
Programmable source control keys and the Programmable numeric keys, as
well as the STANDBY key. An independent set of functions can be assigned
to these keys for each of your audio and video sources, thus allowing you to
control up to 11 different sources attached to your system.
In addition there is also a special case for a TV source, which can be learnt
by the Personal Handset’s volume and balance keys.
When you select an audio or video source the functions of the
programmable keys automatically change to the functions you have learnt for
that source.
The following procedure allows the AV5101 Personal Handset to be
programmed to control other equipment such as VCRs and LaserDisc
players.
E r a s i n g p r e v i o u s l y l e a r n t
c o m m a n d s
Prior to learning a new set of commands from another infra-red handset as a
new source (TUNER, DAT, CD, TAPE, AUX1, AUX2, CABLE, VCR, TV, SAT, or
LASER) on the AV 5101 Personal Handset, previously learnt commands for
that source must be erased from the AV 5101’s memory as follows:
Press the LEARN key.
The LEARN indicator will illuminate.
Press and hold the Audio/Video source select key for the source you
want to erase, and while still holding the Audio/Video source select key,
press and hold the LEARN key.
When the Audio/Video source select key is pressed, the LEARN indicator
blinks once. After the Audio/Video source select key and the LEARN key
have been held for 5 seconds, the memory for the selected source will be
erased and the LEARN indicator turns off.
For example to erase previously learnt VCR commands, after pressing the
LEARN key, press and hold the VCR key, and while holding the VCR key,
press and hold the LEARN key for 5 seconds.