Lexmark 3455 - Manual (Page 85)

85
7.2.1 Selecting the MarkNet Internal Print Server TCP/IP
Protocol Settings
From the printer operator panel, do the following:
1. Press Menu> until the NETWORK MENU displays. Press Select.
2. Press Menu> until the NETWORK OPTION 1 displays. Press Select.
(This example assumes the MarkNet internal print server is installed in
option connector 1.)
3. Press Menu> until you see NETWORK 1 SETUP. Press Select.
4. Press Menu> until you see TCP/IP. Press Select.
Here you find the following settings:
Activate Yes
Enable BOOTP Yes or No
(Yes, if you use a BOOTP server.)
(No, if you set the IP address another way.)
Enable DHCP Yes or No
(Yes, if you use a DHCP server.)
(No, if you set the IP address another way.)
Enable RARP Yes or No
(Yes, if you use a RARP server.)
(No, if you set the IP address another way.)
Set IP Address 157.184.67.102
(Address available from your network administrator)
Set IP Netmask 255.255.255.0
(Appropriate netmask for your network)
Set IP Gateway 157.184.67.1 (IP address of the IP gateway)
Set Hostname Name (Necessary when using DHCP server.)