Lexmark 3455 - Manual (Page 91)

91
7.4.4 Setting the MarkNet XLe Busy Timeout
The recommended setting for the MarkNet XLe Busy Timeout is 0 (disabled). This
allows the host system "release timer" value to control when print jobs from another
protocol, interface, server, or host can be started.
You may set the MarkNet XLe Busy Timeout value to a value greater than the host
"release timer" value. Errors are very likely to occur when the printer requires user
intervention and the intervention is not cleared before the timeout occurs.
Setting the MarkNet XLe Busy Timeout smaller than the host "release timer" value
will result in communication errors after the job has printed.
7.5 Printing IPDS from PSF/400 with OS/400
V3R1 or V3R6
Install the latest cumulative PTF fix pack or tape for the operating system (including
the tool, WRKAFP2).
N
PTF SF29249
PTF SF29249, which is available from IBM, provides the source code for
WRKAFP2 and must be installed. This PTF provides QSYS/QPQXWAFP
program command source code in the PTF cover letter special instructions.
N
PTF SF29961 (V3R1)
N
PTF SF32907 (V3R6)
1. Set up and start the TCP/IP network:
N
Create a Token-Ring or an Ethernet line description for the printer
using
CRTLINTRN or CRTLINETH .
N
Add a TCP/IP interface using ADDTCPIFC .
N
Add a router definition, if required, using ADDTCPRTE .
N
Start TCP/IP using STRTCP .