Lennox Hearth I200 - Manual (Page 14)

10 A-61167 April 2005
System requirements
Minimum system
configuration To operate the scanner, the following minimum configuration is required.
NOTES: The actual performance of the system depends upon the scanning
application, choice of scanning parameters, and the host computer
configuration. If the scanner is not performing at the optimal speed,
a faster computer and/or more RAM may be necessary to obtain the
rated throughput.
• IBM PC (or compatible) with a Pentium III 1 GHz processor
- i260 Scanner: for scanning at 300 dpi with deskew, you will need at least
a 1.8 GHz processor for bi-tonal scanning or a 2.5 GHz processor for
color scanning.
- i280 Scanner: for scanning at 300 dpi with deskew, you will need at least
a 2.5 GHz processor for bi-tonal scanning or a 3.2 GHz processor for
color scanning.
• Microsoft Windows 98SE, Windows Millennium Edition (Me),
Windows 2000, or Windows XP
• 100 MB of available hard disk space (200 MB is recommended)
• 128 MB of RAM
• Monitor (VGA)
• Mouse
Recommended system
configuration To operate the scanner at its optimum speed, the following configuration (or
better) is recommended.
NOTE: The actual performance of the system depends on the scanning
application, choice of scanning parameters, and the host
computer configuration.
• IBM PC (or compatible) with a Pentium IV 3.2 GHz processor
• Microsoft Windows 98SE, Windows Millennium Edition (Me),
Windows 2000, or Windows XP
• 200 MB of available hard disk space
• 512 MB of RAM
• Additional memory (SODIMM) installed in the scanner
- i250 Scanner: up to 256 MB of memory is allowed
- i260 Scanner: up to 256 MB of memory is allowed
- i280 Scanner: up to 512 MB of memory is allowed
• Monitor (VGA)
• Mouse