Lennox Hearth I200 - Manual (Page 47)

A-61167 April 2005 C-5
6. Attach and tighten the fourth thumbscrew on top of the circuit board
mounting bracket.
7. Make sure that the imprinter board is seated and secure.
8. Tighten the three thumbscrews that connect the imprinter board and the
circuit board mounting bracket.
9. Replace the circuit board cover.
10. Secure the circuit board cover with its two screws.
11. Locate the imprinter connector on the circuit board cover.
The imprinter connector should be protruding from the opening on top of
the circuit board cover.
Imprinter connector