Lennox Hearth I200 - Manual (Page 18)

14 A-61167 April 2005
2. Attach the other end of the IEEE-1394 (FireWire) cable to the
host computer.
WARNING: Make sure that the position of the IEEE-1394 (FireWire) cable
connector end correlates to the IEEE-1394 port configuration
before you plug the cable in. Damage to the scanner will
occur if the cable is attached in the wrong position.
IMPORTANT: The i200 Series Scanner should be the only item plugged in to
the IEEE-1394 (FireWire) card on the host computer.
Power setup One or more power cords may be supplied with the scanner. Use only the cord
required for your power type. Dispose of any unneeded power cords properly.
Use only the power supply that was provided with the scanner.
CAUTION: The scanner and power supply must only be used indoors in a
dry location.
IMPORTANT: Do not substitute another power supply model or another
manufacturer’s power supply.
1. Press the side labeled “O” on the power switch to make sure that the
power is off.
NOTE: The power switch is on the power supply.
2. Attach the power cord for your power type to the power supply.
3. Attach the power supply to the power input on the back of the scanner.
On/Off (I/O) power switch