Lennox Hearth I200 - Manual (Page 23)

A-61167 April 2005 19
Using the Scanner
Starting and stopping
scanning
Scanning is controlled by software developed for your application. To start and
stop scanning, refer to the documentation provided with your software.
Automatic feeding
To scan a batch of documents, follow the guidelines for size, type, quantity,
etc., in the Introduction section. For faster throughput, feed documents into the
automatic document feeder (ADF) in landscape orientation (longer side as the
leading edge).
IMPORTANT: Staples and paper clips in documents may damage the scanner.
Remove all staples and paper clips before scanning.
1. Align the leading edges of the stacked documents.
2. Position the leading edge of the documents face down and centered
in the ADF.
3. Adjust the document feeder guides.
4. Adjust the output tray position, if necessary.
5. Pull out the output tray extender, if necessary.
6. Start scanning.
Continuous feeding Continuous feeding allows you to place additional batches of documents in the
feeder for “infinite” feeding (with operator assistance).
• When only a few documents from one batch remain in the feeder, place the
next batch face down on top of those documents.