Linksys Wireless PrintServer WPS11 - Manual (Page 10)

14 13
Bi-Admin: PrintServer Management
Overview
The Wireless PrintServer is managed by a utility program called Bi-Admin on
the Wireless PrintServer’s Setup CD. Fully compatible with Windows 95, 98,
Millennium, NT, 2000, and XP, Bi-Admin allows you to change the Wireless
PrintServer’s internal settings, check on the unit’s status, and perform basic
diagnostic tests. Note that the Bi-Admin program must only be installed on the
network administrator’s computer.
Bi-Admin is a Windows-based program. So if you are using the Wireless
PrintServer in a NetWare DOS-only environment, you must use a program
other than Bi-Admin to manage the Wireless PrintServer.
The Bi-Admin Management Utility should have been installed when the Setup
CD was first inserted. If, however, you need to install it again, simply follow
these directions.
1. Insert the Wireless PrintServer’s Setup CD into your CD-ROM drive.
2. When the autorun screen appears, click the Install tab.
3. Click the Next button on the following screen. When asked for a destina-
tion folder, either click the Next button to choose the default location or
click the Browse button to select a new location
4. The Bi-Admin Management Utility will now be installed.
1. To start the Bi-Admin program, click on Start, Programs, Linksys, and
then PrintServer Bi-Admin. If the Bi-Admin icon has been created, you
can just double-click on it instead. You can drag the shortcut icon onto your
Desktop for easy access to the Bi-Admin program.
Installing the Bi-Admin Management Utility
Starting the Bi-Admin Management Utility
Wireless PrintServer
11. The Printer Port Setup screen will appear again, displaying the printers
which are now communicating with the Wireless-Ready PrintServer. Click
the Next button to any any more printers or Close to complete the installa-
tion and configuration procedure.
Instant Wireless™ Series