Linksys Wireless PrintServer WPS11 - Manual (Page 5)

4
LAN This port connects to your wired network using a
standard Category 5 network cable.
Printer This Parallel (LPT) Port connects to your printer.
Reset Button Briefly pressing the Reset Button will refresh the
Wireless PrintServer’s connections, potentially clear-
ing any jammed links.
Power This port connects the power adapter.
Antenna (not shown) This port, located on the side of the Wireless
PrintServer, is where you will connect the included
antenna by screwing it on securely.
Getting to Know the Wireless
PrintServer
LAN Green. The LAN LED serves two purposes.
If the LED is continuously illuminated, the
Wireless PrintServer is successfully con-
nected to a device through the LAN port. If
the LED is flickering, the Wireless
PrintServer is actively sending or receiving
data to the wired network.
WLAN Amber. The WLAN LED is exactly like the
LAN LED, except that it will show Wireless
Activity. It will stay continuously lit if there
is a wireless connection, and it will flicker
when the Wireless PrintServer is actively
sending or receiving data to the wireless
network.
ACT Green. The ACT LED will remain continu-
ously lit when a printer is correctly connect-
ed to the Wireless PrintServer. The LED will flicker when print jobs
are being transmitted to the printer, over both the wired and wireless
networks.
Err Red. The Error LED lights up when there is a problem printing to the
indicated printer. If this LED lights up, try resetting the Wireless
PrintServer by pressing the Reset button on the back of the Wireless
PrintServer.
3
The Wireless PrintServer’s LEDs
Instant Wireless™ Series Wireless PrintServer
The Wireless PrintServer’s Ports
To reset the factory default settings:
1. Turn the Print Server OFF.
2. Press and hold the diagnostic button. While pressing the button, switch the
Print Server ON.
3. If you continue pressing the button for 10 seconds, a diagnostic page will
be printed, showing the new (default) settings.
To generate a Diagnostic print out
1. Ensure that both the Print Server and the printer attached to port 1 are ON.
2. Press the diagnostic button, and hold it in for 2 seconds.
3. The test page, containing the current settings, will be printed.
PostScript printers are unable to print this page. If you have a PostScript print-
er on Port 1, the test page will not be printed.