Lincoln Electric BULLDOG SVM208-A - Manual (Page 15)

INSTALLATION A-7 A-7
BULLDOG® 140
PREMISES WIRING
The Bulldog® 140 is not recommended for premises
wiring.
The Bulldog® 140 does not have a combined 120/240
volt receptacle and cannot be connected to a premises
as described in other Lincoln literature.
Remember that the Bulldog® 140 is intended only for
backup, intermittent use power.
Certain electrical devices cannot be powered by the
Bulldog® 140. Refer to Table A.2 for these devices.
CIRCUIT BREAKERS
Auxiliary power is protected by circuit breakers. When
the machine is operated in high temperature environ-
ments, the breakers may tend to trip at lower loads
than normally.
Never bypass the circuit breakers. Without over-
load protection, the Bulldog® 140 could overheat
and/or cause damage to the equipment being used.
------------------------------------------------------------------------
CAUTION
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC