Engine will not start, Troubleshooting and repair, Caution – Lincoln Electric BULLDOG SVM208-A User Manual

Page 57

Advertising
background image

ENGINE PROBLEMS

Observe Safety Guidelines detailed in the beginning of this manual.

PROBLEMS

(SYMPTOMS)

POSSIBLE AREAS OF

MISADJUSTMENT(S)

RECOMMENDED

COURSE OF ACTION

If for any reason you do not understand the test procedures or are unable to perform the tests/repairs safely,
contact the Lincoln Electric Service Department for technical troubleshooting assistance before you proceed.
Call 1-888-935-3877.

CAUTION

Engine will not start.

1. Make sure the ON/OFF switch is

in the “ON” position.

2. Check spark plug boot and wire

for loose or faulty connection.

3. Make sure that the fuel shutoff

valve is in the “ON” position.

4. Make certain that the engine has

adequate fuel and oil.

5. Adjust the choke to prevent car-

buretor flooding.

6. The recoil starter may not be

engaged with the engine. gently
hit the blower housing and/or pull
the rope to its fully extended
position and rapidly wiggle it.
Repeat until the clutch engages
with the engine shaft and resis-
tance is felt.

7. Low oil and engine low oil shut-

down protection will not allow
unit to start. Light in ON-OFF
switch will flash when engine is
cranked. (Engines equipped
with low oil shutdown protection
only).

1. Check the fuel line for breaks or

obstructions. Replace the fuel
filter. DO NOT RUN THE EN -
GINE WITHOUT AN IN-LINE
FUEL FILTER.

2. The spark plug may be faulty.

Replace.

3. Service the engine as outlined

in the Maintenance Section of
this manual.

4. The engine magneto may be

faulty. Consult Briggs &
Stratton owner’s manual.

5. The engine may be faulty.

Replace.

TROUBLESHOOTING AND REPAIR

F-9

F-9

BULLDOG® 140

Return

to

Section

T

OC

Return

to

Section

T

OC

Return

to

Section

T

OC

Return

to

Section

T

OC

Return

to

Master

T

OC

Return

to

Master

T

OC

Return

to

Master

T

OC

Return

to

Master

T

OC

Advertising