Lexmark 1020 - Manual (Page 36)

4-3
4078-00X
Access Cover Removal
1. Open the access cover.
2. Push the mounting tabs towards the center of the machine.
3. Remove the access cover.
Base Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Disconnect the power supply connector at the system board.
5. Remove the two screws that secure the carrier frame to the
base assembly.
6. Remove the screw that secures the power supply frame to the
carrier frame.
7. Remove the ground strap screw from the system board.
8. Unlatch the carrier frame from the base assembly and lift it off
the base.
9. Slide the machine off the base assembly.
Carrier Belt Removal
1. Remove the front cover.
2. Remove the retainer spring from the left side of the carrier rod.
3. Remove the screw from the right side of the carrier rod.
4. Slide the carrier rod to the left, out of the machine.
5. Remove the carrier belt from the rear of the carrier.
6. Remove the carrier belt from the carrier transport motor pulley.
7. Remove the carrier belt.