Lexmark 1020 - Manual (Page 44)

4-11
4078-00X
Sheet Feeder Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the two sheet feeder mounting screws from the rear of
the carrier frame.
4. Unlatch the right sheet feeder latch from the front of the carrier
frame.
Note: The cables are routed through tab slots in the sheet
feeder. Note this for reassembly.
5. Remove the sheet feeder.
Small Feed Roll Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Remove the system board.
5. Remove the four small feed roller springs from the carrier frame.
6. Push down on each of the small feed roll assemblies to remove
them from the small feed roll bracket.