LevelOne FBR-1404TX - Manual (Page 75)

LevelOne Broadband VPN Gateway User Guide
Move There are 2 ways to change the order of policies:
• Use the up and down indicators on the right to move the selected
row. You must confirm your changes by clicking "OK". If you
change your mind before clicking "OK", click "Cancel" to reverse
your changes.
• Click "Move" to directly specify a new location for the selected
policy.
Enable/Disable Use this to toggle the On/Off state of the selected policy.
Copy If you wish to create a policy which is similar to an existing policy,
select the policy and click the "Copy" button.
Remember that the new policy must have a different name, and there can
only be one active (enabled) policy for each remote VPN endpoint.
Delete To delete an exiting policy, select it and click the "Delete" button.
View Log Clicking the "View Log" button will open a new window and display the
VPN log.
Adding a New Policy
1. To create a new VPN Policy, click the "Add" button on the VPN Policies screen. This will
start the VPN Wizard, as shown below.
Figure 48: VPN Wizard - Start
• If you prefer to use a single setup screen instead of a Wizard, click the Setup Screen
button. This is recommended for experienced users only.
• Otherwise, click Next to continue. You will see a screen like the following.
72