LSI SAS6160 - Manual (Page 48)

Page 48 LSI Corporation | September 2010
LSISAS6160 SAS Switch User Guide Chapter 3: SAS Domain Manager Graphical User Interface | Domain Tab
3.6.4.5 Activate/Deactivate
Zone Set
Use the Activate/Deactivate Zone Set command to activate or deactivate a zone set.
Only one zone set can be active at a time, and a zone set must be active for its
definitions to be applied to the domain. Changes to the active zone set or zone group
permissions do not take effect until the next zone set activation. When all zone sets are
inactive, zoning is disabled and domain access is unrestricted.
As shown in the following figure, the Activate/Deactivate window lists the currently
active zone set. To deactivate all zone sets, click the button on the left of the window,
and click Apply.
NOTE: The default password for the zone manager is lynx.
To activate a zone set, select it from the pull-down list, type the zone manager
password, and click Apply.
When activated, copies of the zone set and component zone groups are made. An
asterisk at the end of a zone group name indicates that the zone group is currently
active.
Figure 12: Activate/Deactivate Zone Set