LSI SAS6160 - Manual (Page 68)

Page 68 LSI Corporation | September 2010
LSISAS6160 SAS Switch User Guide Chapter 4: SAS Domain Manager Command Line Interface | Sample Output for Show Com-
mand
Device Phys: 32-33-34-35
Parent SAS Address: 500062b10000127f
Parent Phys: 16-17-18-19
Vendor Specific (hex): 00 00 00 00 00 00 00 00
Vendor Specific (ASCII):
- Environmentals Information -
Last Update: Time Not Supported
Chip Temperature: OK, 68 Celsius
Board Temperature: OK, 44 Celsius
Astek-Brann: OK
Expander: OK
J1:Interconnect 32-35: OK, SAS Mini 4i Plug
J2:Uplink 24-27: OK, SAS Mini 4i Plug
J3:Drives 20-23: OK, SAS Mini 4i Plug
J4:Drives 16-19: OK, SAS Mini 4i Plug
J5:Drives 12-15: OK, SAS Mini 4i Plug
J6:Interconnect 28-31: OK, SAS Mini 4i Plug
J7:Drives 00-03: OK, SAS Mini 4i Plug
J8:Drives 04-07: OK, SAS Mini 4i Plug
J9:Drives 08-11: OK, SAS Mini 4i Plug
4.3.5 show domain SDMCLI> show domain
Overlay Name Id Domain Access Point
---------------------------- --- ---------------------------------------------
(Domain) 1 SAS6160 (500062b10000417f)
Note: (Name) denotes focused domain
[Name] denotes domain overlays currently not bound to a physical domain
4.3.6 show phy SDMCLI> show phy
NOTE: In the following example, T = Table, S = Subtractive, and D = Direct.
Notes:
- RA - Routing Attributes
- VP - Virtual PHY
- LS/S - Link Speed/Status: 1.5|3.0|6.0 Gb/s
- phy enabled but link uninitialized
* phy disabled
- ZG - Zone Grp
Zoning Active: Zone Group Number
Zoning Inactive: * phy may be assigned to a zone group
- phy may not be assigned to a zone group
- Capabilities
1xxxxxxxx - Attached SMP Initiator