Figure 10 repo switch connections, 4 external battery cabinet installation, External battery cabinet installation – Liebert PSITM User Manual

Page 17: Caution

Advertising
background image

Installation

13

Figure 10 REPO switch connections

5.4

External Battery Cabinet Installation

Optional Liebert external battery cabinets may be connected to the UPS to provide additional battery

run time. External battery cabinets are designed to be placed all on one side of the UPS or stacked

beneath the UPS. The run time is limited to a maximum of four (4) hours.

1. Visually inspect the external battery cabinet for freight damage. Report damage to the carrier

and your local dealer or Liebert representative.

2. The rack-mount handles are shipped with the external battery cabinet and may be installed at

this time (see 5.3 - Rack-Mount UPS Conversion and Installation).

3. Fixed rails and securing hardware ship with the external battery cabinet. Fasten the fixed rails

into position with the screws per the instructions included with the UPS. Repeat

Steps 1 through 10 from 5.3 - Rack-Mount UPS Conversion and Installation.

4. Use the support bases included with the UPS for the tower option to prevent tip-over. One

additional set of support base spacers ships with each external battery cabinet.

5. Connect the supplied external battery cabinet cable to the rear of the external battery cabinet,

then to the rear of the UPS, as shown at right.

6. The UPS is now equipped with additional backup battery run time. For approximate battery run

times, refer to Table 5 - Battery run times.

!

CAUTION

The external battery cabinet(s) are heavy (see 12.0 - Specifications). External battery

cabinets can be used in rack-mount or tower configuration. Take proper precautions when

lifting them.

REPO connections

for normally open

switch system

REPO Switch

as shipped

REPO connections

for normally closed

switch system (fail-safe)

1 2 3 4

Key to REPO switch connections
1.

24 VDC,

2.

Sense

3.

Sense

4.

Ground

REPO Connector

1 2 3 4

1 2 3 4

INPUT

BREAKER

PUSH TO RESET

INPUT

LOAD 1

LOAD 2

BATTERY
CONNECTOR
1440VA/DC 48V/30A
1000VA/DC 48V/20A

INTELLISLOT

1
2
3
4

REPO

PHONE / FAX / MODEM / NETWORK

PROTECTION

IN

OUT

+

-

RS-232

BATTERY
CONNECTOR

BATTERY
CONNECTOR

Advertising