Linear AE-100 - Manual (Page 28)

28
U N I T S :
A R E Y O U S U R E ? 5
( E R R O R M E S S A G E )
L o w B a t t e r y
N O A C
C O M M U N I C A T I O N
E R R O R U N I T #
C L E A R E R R O R L O G ?
Y E S E N T E R 5
U N I T S R E S P O N D I N G
L A N G U A G E : 1 - 4
ALTERNATE PROGRAMMING METHOD
FUNCTION CODE LOCAL PROGRAMMING TELEPHONE PROGRAMMING
34
COPY ALL MASTER
MEMORY TO
SUB-UNITS
To synchronize programming
in multi-unit installations, all
system data can copied from the
master unit to selected sub-units.
This data includes the Directory
Entries, Stand-alone Access
Codes, and all system option
settings (except the sub-unit
number).
NOTE: This utility command
can only be performed from the
“master” unit.
CAUTION: This utility
command will overwrite ALL
data in the sub-unit(s) selected.
Step 1 Enter Function Code 34, then press #.
Step 2 Enter the number(s) (2, 3, and/or 4) of all the
sub-units to copy the data to, then press #.
Step 3 Enter 5 for verifi cation, then press #.
- OR -
Enter
✱ to cancel this command.
NOTE: Function Codes 7 and 8 must be programmed
before this command will operate.
Step 1 Enter Function Code 34 and
press #, one short beep sounds.
Step 2 Enter the number(s) (2, 3, and/or 4)
of all the sub-units to copy the data to,
then press #, one short beep sounds.
Step 3 Enter 5 for verifi cation, then press #,
two short beeps sound. (Any entry other
than 5# will cancel the command.)
NOTE: To allow for multi-unit network
communications, when executing this
command remotely over the telephone,
the system will disconnect your call
after Step #3 then copy the data from
the master unit to the sub-units.
35
DISPLAY/CLEAR
SYSTEM ERRORS
The system’s power indicator will
fl ash if any system errors occur.
These errors include loss of AC
power and low backup battery. In
multi-unit installations, the master
unit logs communication errors
with sub-units.
Step 1 Enter Function Code 35, then press #.
If there are any errors, they will be
displayed. Possible error messages are:
Step 2 Press # to display the next error message (if any).
Step 3 After the last error message, the option
to clear the error log will be displayed.
Enter 5 and press # to clear the log, or
just press # to keep the log and exit.
NOT AVAILABLE
37
POLL SUB-UNITS
In multi-unit installations, this
utility command will instruct the
master unit to poll (request and
receive communications) the
sub-units. This command is used
for testing purposes only.
Step 1 Enter Function Code 37, then press #.
Step 2 The display will show the numbers of sub-units that
responded error free on the fi rst try. Press ✱ to exit.
Step 1 Enter Function Code 37 and press #.
If all sub-units respond error free,
three short beeps will sound.
If any sub-units don’t respond error
free, two long beeps will sound.
38
SYSTEM DISPLAY
LANGUAGE
The factory default language is
English. Three other languages
can be selected as the language
for the user and programming
displays.
NOTE: The system supports one
display language at a time.
Step 1 Enter Function Code 38, then press #.
Step 2 Enter:
1 for English (Default).
2 for Spanish.
3 for French.
4 for Portuguese.
Step 3 Press #.
NOT AVAILABLE