Lexicon MPX G2 - Manual (Page 78)

5-13
System Controls
Clear Programs This control allows you to clear a single User program, or any number of
consecutively numbered User programs.
From the Clear Programs screen, press > to display the following screen.
Two fields are available for selecting any num-
ber of User programs between 251 and 300.
Clear Programs
251 to 300
Are you sure?
Yes or No
Press Yes to clear the se-
lected programs. Press No to
cancel the operation.
The Store button will flash. Pressing it
will display the following message ...
Press Store. The display query "Are you sure?" prompts you to select Yes or No
as a response. If you don't want to perform the initialization, press No to cancel
the operation. If you press the front panel Yes button in response to this
message, the procedure will be performed immediately. The message Init
Complete indicates that the procedure has been performed.
Note that the time for reinitialization will vary, with selections including DataBase
reset taking more time.
The selections in this menu are as follows:
All: Resets all MPX G2 parameters to their original factory settings.
This will erase all User programs and Setups.
User pgms only: Erases all User programs (program #s 251-300).
System only: Resets all MPX G2 parameters except User programs.
Controllers: Resets the MPX G2 internal controllers (Knob, LFOs, etc.) to their
default settings.
Bypass Patches: Removes any patches made between Bypass buttons and external
controllers.
Global Patches: Clears all global patches.
DataBase: Resets DataBase assignments for all programs.
This will remove DataBase assignments from programs 251-300.
MPXG2/R1: Resets the MPX G2 and any connected MPX R1 to the original factory
settings of all remote parameters such as Bypass Patches, Continu-
ous Controller assignments, etc.