Troubleshooting & repair, Control board removal and replacement (continued) – Lincoln Electric PRO-CUT 55 SVM140-A User Manual
Page 88
Advertising
TROUBLESHOOTING & REPAIR
F-51
F-51
PRO-CUT 55
PROCEDURE
1. Remove input power to the Pro-Cut 55
machine.
2. Remove the wraparound cover and perform
the Input Filter Capacitor Discharge
Procedure detailed earlier in this section.
3. Using the 5/16” nut driver, remove the four
screws holding the front assembly to the top
and base of the machine. See Figure F.16.
4. Carefully slide (do not force) the front away
from the rest of the machine about one inch.
This will allow more “working” room to
remove the control board.
CONTROL BOARD REMOVAL AND REPLACEMENT (continued)
4 SCREWS
CONTROL
BOARD
MOLEX PLUGS (5)
FIGURE F.16 - CASE FRONT SCREW REMOVAL
FIGURE F.17 - CONTROL BOARD MOLEX PLUG REMOVAL
Advertising