Linksys PSUS4 - Manual (Page 16)

9 Chapter 4: Installing the PrintServer using the Setup Wizard
Installation
PrintServer for USB with 4-Port Switch
8. The IP Settings screen, Figure 4-6, appears next. If your network uses a router with a DHCP Internet Protocol
setting that automatically assigns an IP address, select Automatically obtain an IP address (DHCP). If your
network uses a static IP address, select Set IP configuration manually, and enter the IP Address, Subnet
Mask, and Gateway in the fields provided. Click Next.
Click Back to return to the previous screen.
9. The next screen that appears is the Set PrintServer’s Password screen, shown in Figure 4-7. If you want to
change your password, enter your current password in the Current Password screen. Enter the new password
in the New Password field, then enter it again in the Verify Password field. Click Next.
Click Back to return to the previous screen.
Figure 4-6: IP Settings
Figure 4-7: Set PrintServer’s Password