Linksys PSUS4 - Manual (Page 17)

10 Chapter 4: Installing the PrintServer using the Setup Wizard
Installation
PrintServer for USB with 4-Port Switch
10. The Confirmation screen appears next. See Figure 4-8. Your old and new settings will be displayed. If you
want to make a change, click No and you will exit the Setup Wizard; You will have to start the Setup Wizard
again. If the settings are correct and you want to save the changes, click Yes.
11. The Congratulations screen, shown in Figure 4-9, will appear. The Setup Wizard is complete.
You will need to install the driver next. To continue and install the driver, click User Install at the bottom of
the Congratulations screen, and go to Chapter 5: Driver Installation.
Figure 4-8: Confirmation
Figure 4-9: Congratulations