Linksys PSUS4 - Manual (Page 40)

33
PrintServer for USB with 4-Port Switch
Chapter 8: Bi-Admin Management
The Bi-Admin Management Utility
TCP/IP
If you are using DHCP to assign IP addresses, select Dynamic IP Address (DHCP) . (See Figure 8-16.) By
default, Dynamic IP Address (DHCP) is enabled. If you need to assign the PrintServer a Fixed IP Address (also
known as Static IP Address), select Fixed IP Address, (Figure 8-17) and enter the appropriate values under IP
Address, Subnet Mask, and Gateway. To find your router’s IP address, consult your router’s documentation.
The IP Address and Subnet Mask are the same as those of any PC connected to the network. If you change
the PrintServer’s IP address, make sure you that you reconnect to the PrintServer using that new IP address.
Otherwise, you will not be communicating with the PrintServer. The Gateway IP Address is not necessary for
using the PrintServer.
Click the Get Defaults button if you want to return the settings to the default settings.
When finished making your changes on this tab, click the OK button to save these changes, or click the
Cancel button to undo your changes. For more information, click the Help button.
Figure 8-16: Dynamic IP Address (DHCP)
Figure 8-17: Fixed IP Address