Lexmark 4059-XXX - Manual (Page 154)

3-21 4059 Service Manual
4059-XXX
ID" message displays on Line 2 before the ID redisplays. You
have to reenter the Configuration ID until a valid ID is verified. If
the ID is valid then the ID is saved in NVRAM and the printer
automatically PORs to activate the new setting.
Note: When the printer PORs it does so in the normal mode.
Restore EP Factory Defaults
To restore each of the printer settings contained in the EP Setup
menu to their factory default value select Restore from the menu. To
exit the menu without restoring the settings to the factory default
values, select Do Not Restore. Sometimes this is used to help
correct print quality problems.
Fuser Temperature
This adjustment can be used to help solve some customer problems
with paper curl on low grade papers and or problems with letter
heads on some types of media.
The fuser temperature can be adjusted as follows:
•
NORMAL
•
LOWER
•
LOWEST
Warm Up Time
You can change the amount of time the printer warms up before
allowing pages to print by changing this setting from 0 to 5. The
factory sets the warm up at 0 or no warm up time. This time period
allows the backup roll to heat up and helps reduce curl in some
environments.
Transfer
The transfer can be adjusted as follows:
•
LOW
•
MEDIUM
•
HIGH