Lincoln Electric IDEALARC IM10018-A - Manual (Page 10)

A-2 INSTALLATION
IDEALARC® DC-600 VRD
A-2
SAFETY PRECAUTIONS
Read entire Installation Section before
installing the IDEALARC® DC-600 VRD.
ELECTRIC SHOCK CAN KILL.
• Only qualified personnel should
install this machine.
• Turn the input power OFF at the
disconnect switch or fuse box
before working on the equipment.
• Do not touch electrically hot parts.
• Always connect the IDEALARC® DC-600 VRD
grounding terminal to a good electrical earth
ground.
• Set the IDEALARC® DC-600 VRD Power ON/OFF
PUSH bUTTON to the OFF position when con-
necting power cord to input power.
__________________
SELECT PROPER LOCATION
Place the welder where clean cooling air can freely
circulate in through the front louvers and out through
the rear louvers. Dirt, dust or any foreign material that
can be drawn into the welder should be kept at a mini-
mum. Failure to observe these precautions can result
in excessive operating temperatures and nuisance
shut-downs.
LIMIT ON STACKING
STACKING
Three IDEALARC® DC-600 VRD machines can be
stacked.
DO NOT stack more than three machines in one
grouping.
DO NOT stack the IDEALARC® DC-600 VRD on
another type of machine.
Follow these guidelines when stacking:
1. Select a firm, level surface capable of supporting
the total weight of up to three machines (1570
pounds/712 kilograms).
2. Set the bottom machine in place.
3. Stack the second machine on top of it by aligning
the two holes in the base rails of the second
machine with the two pins on top front of the bot-
tom machine.
4. Repeat process for third machine.
NOTE: The machines must be stacked with the Case
Front of each machine flush with each other. See
Figure A.1.
FIGURE A.1 - Stacking IDEALARC® DC-600
VRD machines
TILTING
The IDEALARC® DC-600 VRD must be placed on a
stable, level surface so it will not topple over.
STACKING HOLE STACKING PINS
STACKING HOLE
STACKING PINS
WARNING
• Lift only with equipment of ade-
quate lifting capacity.
• be sure machine is stable when
lifting.
• Do not lift this machine using lift
bail if it is equipped with a heavy
accessory such as trailer or gas
cylinder.
FALLING • Do not lift machine if lift bail is
EQUIPMENT can damaged.
cause injury. • Do not operate machine while
suspended from lift bail.
• Do not stack more than three high.
• Do not stack the IDEALARC® DC-600 VRD on top of
any other machine.
------------------------------------------------------------------------
WARNING