Lowrance electronic iFINDER M-M - Manual (Page 15)

9
Cigarette Lighter Power Adapter
To use external DC power: Plug the power cable's cigarette lighter
adapter into a cigarette lighter receptacle. Next, pull aside the rubber
cover on the bottom of the unit and insert the other connector as shown
in the following image. A small clip on the connector should hold the
connector in place.
Attach external power cable to iFINDER.
WARNING:
Do not remove the cigarette lighter adapter and splice
the exposed wires directly to a 12-volt power system. The
cigarette lighter adapter contains in the plug a protec-
tive fuse and a voltage regulator to convert 12 volts
down to about 3 volts. Without this regulator, connecting
your unit to a 12-volt power source will destroy the unit.
This damage will not be covered by your warranty.
The iFINDER can use two other optional external cables to supply a
NMEA/serial data connection or a combination of power and data. These
cables are discussed in the following segment on NMEA connections.
Headphone Adapter
The iFINDER Map & Music comes with a cable adapter that allows you
to plug in your headphones. To use this adapter: Plug your headphones
into the standard audio socket on the adapter. Next, pull aside the rub-
ber cover on the bottom of the unit and insert the other connector as
shown in the following image. A small clip on the connector should hold
the connector in place.
offered by www.Busse-Yachtshop.de email: [email protected] Tel: +49 (0)4347 908234