Lifescan SureStep - Manual (Page 71)

Beep Signals
The SureStep ® Blood Glucose Meter
uses beeping tones to signal various
steps in the meter procedures.
However, these tones do not indicate
that the procedures are being per-
formed correctly. The meter is pre-set
to emit three different beep signals:
1. A single, short beep signals each
step in the test procedure.
2. A single, long beep accom-
panies error messages, a “ ”
result, and certain mistakes in
doing the test procedure.
3. A three-tone beep sounds when
the meter displays a test result
and when the meter is in set-up
mode on the beep signal feature.
In set-up mode, when you move to
the beep signal feature, the meter
will sound a three-tone beep and
flash this message:
If you want the meter to operate
without beeps, press the green C
button to turn off the beep signals.
The following display will appear:
60
SETTINGS
LSC-99-005 CanSS(RR)OB/Eng 1/5/00 4:03 PM Page 60