Line 6 POD X3 Family - Manual (Page 33)

Reference: Tweaking Tones
3•1
r
eferenCe
: t
weAkinG
t
ones
Amp + Cab
Type – turn this knob to select Guitar Amp Models, Bass Amp Models or Pre-Amp type Models.
Select Knob – once the Type has been selected, turn the Select Knob to pick an Amp Model. The Model
names will appear at the top of the display.
Cab – spins through the available Cabinet Models. The available cabs will change depending on the Amp
Model that is chosen.
Mic – changes the microphone selection.
Room - adjusts the amount of “room tone” in your sound. Low settings give you the sound of moving the
virtual microphone closer to the virtual cabinet (you’ll hear only a small amount of the early reflections caused
by the sound echoing in the room). Higher settings increase the early reflections, as if you moved the mic
farther from the cabinet.
Byp Vol - sets the Bypass Volume, the volume that this tone will be set to when the Amp+Cab block is off. It
doesn’t affect the volume you hear with the Amp+Cab block on.
Tone Controls
Tone Controls adjust the overall tone of the currently-loaded Amp Model. You should know that these controls
are individually crafted for each Amp Model, so their response and interactivity will change depending on
the Amp Model that is selected. For Guitar and Bass Amp Models, these correspond to the dedicated Tone
Control knobs on the front panel of your POD X3, POD X3 Live or POD X3 Pro.
Momentary Display: When any of the physical Tone Control knobs are adjusted on the front panel, this
edit page will be displayed, allowing you to see your settings as you tweak the controls. After 2 seconds of