Line 6 POD X3 Family - Manual (Page 38)

Reference: Tweaking Tones
3•6
Delay
Select Knob – turn to pick a Delay model.
Time – for mono delays, sets the time for the delay line; for stereo delays, sets the time for the left side
delay line.
Tap – set this to OFF to have this effect ignore tempo, or pick a note value that you’d like your speed to
match; works with the Tap button/footswitch and the Tempo knob.
Tempo – Shows the tempo that’s been set by Tap, and lets you fine tune it.
Mix – controls the ratio of wet (effected) to dry (non-effected) sound that is heard.
Bass – bass tone control.
Treble – treble tone control.
Fdbk – adjusts how much of the delayed signal is fed back to the input of the delay.
Config – allows you to choose the position of the Delay pedal in your signal flow: Pre (before the amp
model), or Post (after the amp model).
ModSpd – for delays with modulation, controls how fast (or slow) the modulating waveform sweeps.
Depth – for delays with modulation, controls the overall amplitude of the modulating wave.
Drive – for Tape Delay models, adds some tube warmth.
Flut – for Tape Delay models, adjusts wow-and-flutter, that unique sound of a slipping, dirty capstan.
Heads – for some Tape Delays, enables you to choose from the available combinations of the model’s
virtual tape heads.
Speed – is the speed of the modulation for a modulated Delay Model.
L-Fdbk – for Stereo Delays, controls the left-channel feedback.
R-Fdbk – for Stereo Delays, controls the right-channel feedback.
Offset – for Stereo Delays, sets the time for the right side delay line, as a percentage of the left delay’s
Time setting.
Spread – for Stereo Delays, sets the stereo spread of the delays from mono to hard-panned left and
right.