Panasonic DMP-B500 - Manual (Page 41)

Re
fe
re
n
c
e
Se
tti
n
g
s
VQT2J81
(ENG)
41
Refer ence Enjoying High Bit rate Audio and Video
The audio output differs depending on the settings on the unit. ( > 37, “Digital Audio Output”)
≥ The number of channels listed is the maximum possible number of output channels.
[BD-V]
This unit supports high bit rate audio (Dolby Digital Plus, Dolby TrueHD, DTS-HD High Resolution Audio and DTS-HD Master
Audio) adopted in BD-Video.
In order to enjoy these audio formats, the following conditions are necessary. (Part shown in the shaded area of table given above)
NECESSARY CONNECTIONS
≥ HDMI AV OUT terminal: (> 28)
NECESSARY SETTINGS
≥ Set “BD-Video Secondary Audio” to “Off”. (> 37)
≥ Set “HDMI Audio Output” to “On”. (> 39)
≥ HDMI AV OUT terminal: Set “Dolby D/Dolby D +/Dolby TrueHD” or “DTS/DTS-HD” to “Bitstream” or “PCM”. (> 37)
≥ The button click sound on the menu and audio with secondary video in picture-in-picture mode (> 18) is not output.
About audio output
“Dolby D/Dolby D +/Dolby TrueHD”/
“DTS/DTS-HD”
“Bitstream” *1
*1 When the connected equipment is not supported with these audio formats, the audio is output as Dolby Digital bitstream, DTS
Digital Surround bitstream or down-mixed 2ch PCM (e.g., TV).
“PCM” *2
*2 When the connected equipment is not supported with multi channel surround, the audio is output as down-mixed 2ch PCM.
“BD-Video Secondary Audio” “On” *3
*3 When playing BD-Video without secondary audio or button click sound, the audio is output as the same format as if “BD-Video
Secondary Audio” was set to “Off”.
“Off” “On” “Off”
Dolby Digital/
Dolby Digital EX
Dolby Digital
Outputs using
original audio
5.1ch PCM
Dolby Digital Plus/
Dolby TrueHD
DTS Digital Surround/
DTS-ES DTS Digital
Surround
DTS-HD High Resolution Audio/
DTS-HD Master Audio
7.1ch LPCM 5.1ch PCM
Enjoying High Bit rate Audio of BD-Video
DMPB500PP-VQT2J81_eng.book 41 ページ ２０１０年３月１６日 火曜日 午後４時８分