Panasonic DMP-B500 - Manual (Page 45)

Re
fe
re
n
c
e
VQT2J81
(ENG)
45
Cannot obtain IP address using DHCP.
Please check the connection or router settings.
¾ If you use a hub, then check the connection between the hub
and the router.
jUse the UPLINK port of the hub to connect to a router.
( > 31)
jCheck whether or not the hub’s Link lamp lights up. If it
does not light up, then check the cable connection, LAN
terminal connection, cable itself (a crossover cable may
have been used by mistake), etc.
¾ If the above conditions are OK, then the router may not
operate in DHCP mode. Check the router settings and
operation. You may reset the router to restore it to normal.
This IP address is already in use.
Please check the IP address setting.
¾ This unit’s IP address is used by another device. Check the
IP addresses of this unit, personal computers, and routers,
etc. If necessary, reconfigure them to avoid IP addresses
from being duplicated.
Unable to perform Connection Test.
Please try again.
IP address not set correctly.
¾ Turn the unit off. Disconnect the power source (the AC
adaptor or battery pack) and reconnect it and try again. If the
same symptom persists, then consult your dealer.
Connection Test was unsuccessful. No reply
from host.
Please check the connection or router settings.
¾ If you use a hub, then check the connection between the hub
and the router. ( > 31)
jUse the UPLINK port of the hub to connect to a router.
jIf the hub’s Link lamp does not light up, then check the
cable connection, LAN terminal connection, cable itself (a
crossover cable may have been used by mistake), etc.
¾ Check the “IP Address”, “Subnet Mask”, and “Default
Gateway” in the “IP Address / DNS Settings”. ( > 39)
¾ If the MAC address information is required, then press
[SETUP] to display the “Network” menu. ( > 39)
Cannot connect to network.
Please confirm Network Settings or BD-Live
Internet Access in Setup.
¾ When you set “BD-Live Internet Access” to “Allow ( Limited )”
and play BD-Live contents which do not have a content
owner certificate, the Internet access of the content is not
allowed. If you allow the content to connect to Internet, set
“BD-Live Internet Access” to “Allow ( ALL )”. (
> 37)
DMPB500PP-VQT2J81_eng.book 45 ページ ２０１０年３月１６日 火曜日 午後４時８分