Polycom TransTalk 9000-Series - Manual (Page 302)

Feature Reference
5-192
Message Light On (F09XX)
Description
This feature turns on the message light at a specified extension (where XX is a
system extension number).
Related Features
■
For instructions on turning off the message light, see ‘‘Message Light Off
(F10XX)’’ on page 5-190.
■
You may be able to use this feature to signal someone at a doorphone
extension. See ‘‘Doorphone Extension (#604 and #605)’’ on page 5-124.
Considerations
■
This feature turns on the message light on system phones and standard
phones that have message lights. (See ‘‘Standard Telephones’’ on page
1-16 for a list of standard phones that have message lights.)
■ For message-waiting capability, standard phones with LED-compatible
message-waiting lights must be connected to a PARTNER ACS processor
or 308EC module, or to an R3.0 or later 206 module in a system equipped
with a PARTNER ACS processor module.
■
On a standard phone, the message light flashes (only when the phone is
idle) to indicate that the extension has received a message.
■ Do not use this feature for an extension that is covered by the voice
messaging system. The voice messaging system automatically turns on
the message light at a subscriber’s extension when a message is left in the
mailbox.
■
If you use this feature to signal someone at a doorphone extension, you
must use Message Light Off to turn the light off.
■ You can program a Message Light On button on a system phone to turn the
message light on at a specific extension with one touch.
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a Message Light On button:
1. Press f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.