Printek 4000se - Manual (Page 31)

D A I L Y O P E R A T I O N
23
UNLOAD / FORM
SELECT
If paper is currently loaded (no paper out
condition exists), this button unloads the paper
and places the top edge of the paper in the
tractors in the base of the unit. This allows you to
change the paper easily. A paper out condition is
displayed to indicate that the paper was unloaded
successfully.
The printer will attempt to unload up to 36
inches of paper. If the top edge of the paper is
not found, paper motion will stop and “Too
Much Paper” will be displayed on the LCD
display. Normally, previous pages should be torn
off before you press UNLOAD. It is
recommended that you not use this method to
unload more than the current form.
When no paper or form is currently loaded, this
button selects one of ten preset form setups. In
the FormsPro 4503se, this may also select a
different set of tractors to be used the next time
you press the LOAD button.
The printer will not allow you to change the form
during printing. If you press the FORM SELECT
button while there is still a line to print, the button
press is rejected, the bell sounds, and the
message “Finish Printing!” flashes on
the LCD display. If this happens, you should
place the printer back on-line, allow the form to
finish printing, and then place the printer off-line
and select the desired new form. If you press
and hold this button at power-up/reset on the
FormsPro 4503se, and paper has not been
loaded, the tractor shuttle moves all the way
forward to its parked position.
Note: The tractor shuttle should always be
parked and secured whenever the printer is
being transported.