Printek 4000se - Manual (Page 48)

D A I L Y O P E R A T I O N
40
Too Much Paper to Unload
This error occurs when the UNLOAD button has been pressed and there is
paper present too far beyond the tear bar. This error serves as a warning
that you may be placing forms that have already been printed on back into
the printer. Tear off any printed forms past the tear bar and press UNLOAD
again. This error also occurs if the LOAD button has been pressed and the
current form cannot be unloaded.
Selected Form is not Loaded
This error occurs when ONLINE has been pressed and the currently selected
form is displaying Not Loaded. Either press LOAD to load the
selected form or select a different form and then press ONLINE.
No Ribbon or Wrong Ribbon
This error occurs when the printer is attempting to go on line and cannot
detect the presence of a ribbon cartridge. This may be due to the ribbon
not actually being present in the printer, or the ribbon may not be installed
properly.
This error may also occur when attempting to use a non-Printek brand
ribbon. Before attempting to use a ribbon brand other than Printek, please
read “
Why Use Only Printek® Brand Ribbons ” on page 10. Then if you do
decide to use non-Printek brand ribbons, refer to “ Ribbon Checking ” on
page 67.
Ribbon Lid Open
This error occurs when ONLINE has been pressed and the ribbon lid has
been left open. Close the lid and press ONLINE again.
Change Ribbon
This message is periodically displayed when a ribbon has reached the end
of its useful life and indicates that a new Printek ribbon should be installed.
This error is merely a reminder to change the ribbon and does not force the
printer off line.