Printek 4000se - Manual (Page 34)

D A I L Y O P E R A T I O N
26
Continue to press the UNLOAD/FORM SELECT button until the desired
form name is shown on the top line of the display. When the desired
form is displayed press the LOAD/FORM FEED button. The form name
will be FORM 0 through FORM 9 or the actual name of the form if
the name has been set in Setup. If the desired form is not considered
to be “loaded” by the printer, <Not Loaded> will flash on the
bottom line of the display. In the case of the FormsPro 4503se the
Not Loaded message will alternate with the path(s) that this form is
to be loaded in.
Changing the Form in the Tractors
1. To unload the currently loaded paper or form, place the printer
offline and press the UNLOAD/FORM SELECT button. This
positions the top of the paper in the tractors in the base of the
printer.
2. To open the case for access to the tractors, pull out on the bottom
of the lower front panel of the printer to release the latch as shown
below:
Opening The Latch Panel