Printek 4000se - Manual (Page 47)

D A I L Y O P E R A T I O N
39
Common Error Conditions
Whenever the printer detects an error condition, it will automatically go off
line. User correctable errors are “flashed” on the display. These errors can
typically be recovered from without loss of data and are listed in this section
of the manual.
Other errors, which typically result in loss of data, are considered fatal
errors. These errors display the word ERROR on the top line of the display
and do not flash. These errors are listed in the “
MAINTENANCE AND
TROUBLESHOOTING ” section of this manual.
Check Paper
This error is caused either by running out of paper or by a paper jam. The
printer will attempt to determine the cause of a paper problem and
accompany the “Check Paper” message with “Paper Out”,
“Paper Jam”, or “Paper Out/Jam”.
If the error is caused by a paper jam, remove the jammed form. If the form
remaining in the tractors has tears along the top edge, remove it from the
tractors, tear it off, and place the next form in the tractors.
If the error is caused by running out of paper, simply place a new box in the
print stand and place the first form in the tractors.
Finally, place the printer back on line by pressing the ONLINE button. This
will automatically load the new form and begin printing. Depending upon
how the printer has been set up, the printer may start printing where it left
off or it may start at the beginning of the page where the error occurred and
reprint the entire page. See “
Paper Out Fault Action ” on page 64 for more
information.
No Paper to Load
This error occurs when the LOAD button has been pressed and there is no
paper or form in the tractors. Place paper in the tractors and press LOAD
again.