Printek 4000se - Manual (Page 55)

P R I N T E R C O N F I G U R A T I O N
47
When shipped from the factory, the Form Names will be set to “ FORM 0 ”
through “ FORM 9 ”. This name may be changed to any combination of
capital letters ( A-Z ), numerals ( 0-9 ), or spaces. The name may be up to 16
characters in length.
Entering a name uses the CURSOR button and either VALUE buttons. The
CURSOR button will advance the cursor, a flashing block, which is used to
indicate the character that is to be changed. The VALUE buttons will change
the character where the cursor is currently flashing. The order of characters
that may be selected is “ABCDEFGHIJKLMNOPQRSTUVWXYZ,
Space, 0123456789”. Even though the name will be right justified
while being entered, it will be automatically centered on the display when
not in Setup Mode, so there is no need to try to center it with spaces.
Tractor Path Tractor Path
Front
Possible Values: Front, Center, and Rear
This item is only available in the FormsPro 4503se and is used to set the
tractor path to be used for the currently selected form. Typically, most
forms are only loaded in one tractor path and the value will be set to
Front, Center, or Rear.
Automatic Cut Automatic Cut
No
Possible Values: No*, Yes
This item is only available when the optional FormsCutter is installed in the
printer. When set to
Yes , the printer will automatically cut each form at the
perforation (based upon the Form Length setting) and eject the form into
the paper basket that is installed with the FormsCutter. If set to
No , the
paper will exit through the top of the cutter and into the basket on the print
stand. To manually cut a form or report at the end of the current page, the
user can take the printer offline and press the UNLOAD button. See the
FormsPro 4000se Series FormsCutter Manual for additional information.