Pioneer Super Tuner III D AVH-P6550DVD - Manual (Page 62)

Introduction of DSP
adjustments
1
You can use this unit to control multi-channel
processor (DEQ-P7050), which is sold sepa-
rately.
By carrying out the following settings/adjust-
ments in order, you can create a finely-tuned
sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Adjusting the time alignment
4 Adjusting the speaker output levels using a
test tone
5 Selecting a cut-off frequency
6 Adjusting the speaker output levels
7 Adjusting 3-band parametric equalizer
1 DSP display
Shows the DSP function names.
% Touch A.MENU and then touch AUDIO
to display the DSP function names.
The DSP function names are displayed and
operable ones are highlighted.
# When A.MENU is not displayed, you can dis-
play it by touching the screen.
# You can also display MENU by clicking the
joystick.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# When playing other than the DVD disc, you
cannot switch to D. R. C or DUAL MONO.
# When neither FRONT-L nor FRONT-R is se-
lected in POSITION, you cannot switch to
TIME ALIGN.
# When neither CUSTOM1 nor CUSTOM2 is se-
lected as an equalizer curve, you cannot switch
to PEQ.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Note
If you do not operate the DSP function within
about 30 seconds, the display is automatically re-
turned to the source display.
Using the sound field control
The SFC function creates the sensation of a
live performance.
! The acoustics of different performance en-
vironments are not the same and depend
on the extent and contour of space through
which sound waves move and on how
sounds bounce off the stage, walls, floors
and ceilings. At a live performance you
hear music in three stages: direct sound,
early reflections, and late reflections, or re-
verberations. Those factors are programed
into the SFC circuitry to recreate the acous-
tics of various performance settings.
1 Press EQ and hold to switch to SFC
function.
Press EQ and hold until SFC appears in the
display.
# To switch to equalizer function, press EQ and
hold again.
DigitalSignalProcessor
En
62
Section
14