Pico Macom SIRD-FTA - Manual (Page 3)

1.1 Safety Instructions
Read the following recommended safety precautions before using this
Receiver. Refer to other provided manuals and instructions for equipment that
will be connected to this Receiver.
Placing the Receiver
Place the Receiver indoors to prevent exposure to lightning, rain and
direct sunlight.
Do not place the Receiver on soft furnishings or carpets.
Allow plenty of space around the Receiver for sufficient ventilation.
Do not place the Receiver where it may be exposed to direct sunlight or
near a heater.
Do not cover the Receiver or place it on a unit that emits heat.
Do not stack other electronic equipment on top of the Receiver.
Preventing Electrical Shock and Equipment Damage
Do not overload wall outlets, extension cords or convenience receptacles
because this can increase the risk of fire or electrical shock.
The ground of the LNB cable must be connected to the system ground for
the satellite dish. Grounding procedures should comply with local regulations.
Do not connect or modify cables when the Receiver is plugged in.
Do not open the Receiver casing; it will cause a hazard.
Do not use any attachments that are not recommended because they may
cause hazards or damage the equipment.
Do not use the Receiver if it has been dropped or the casing has been
damaged. Disconnect the Receiver immediately and take it to a qualified
service center.
Cleaning the Receiver
Unplug the Receiver from the wall outlet before cleaning.
Use a soft cloth and a mild solution of dish-washing liquid to clean the casing.
Never allow liquids, spray or other materials to come into contact with vents
or the inside of the Receiver.
Do not immerse the Receiver in water.
Repairing the Receiver
Do not attempt to repair this Receiver yourself. It will void your warranty and
could cause an electrical shock or equipment damage. Take the Receiver to
a qualified service center.
1.1 Safety Instructions
3
GENERAL INFORMATION