Panasonic WV-NP244 - Manual (Page 40)

40
[HTTP port]
Assign the port numbers independently.
The following port numbers are unavailable since they
are already in use.
Available port number: 1 - 65535
Default: 80
<Port numbers already in use>
20, 21, 23, 25, 42, 53, 67, 68, 69, 110, 123, 161,
162, 995, 10669, 10670
[DNS]
Select "AUTO" or "MANUAL" to determine whether or
not to use the DNS. When "MANUAL" is selected, it is
necessary to configure the settings for the DNS.
When using the DHCP function, it is possible to obtain
the DNS address automatically by selecting "AUTO".
Refer to the network administrator for further information
about the settings.
Default: MANUAL
[Primary DNS], [Secondary DNS]
When "MANUAL" is selected for "DNS", enter the IP
address of the DNS. Refer to the network administrator
about the IP address of the DNS.
[Line speed]
Select the line speed for data transmission from the fol-
lowings. It is recommended to use with the default set-
ting "AUTO".
AUTO/100 MF (Mbps full-duplex)/100 MH (Mbps half-
duplex)/10 MF (Mbps full-duplex)/10 MH (Mbps half-
duplex)
Default: AUTO
[FTP access]
Select "Allow" or "Forbid" to determine whether to allow
or forbid the FTP access.
Default: Allow
[Total bit rate]
Select the total bit rate for data transmission from the
followings.
64 kbps/128 kbps/256 kbps/512 kbps/1024 kbps/
1536 kbps/2048 kbps/3072 kbps/4096 kbps/Unlimited
Default: Unlimited
Notes:
• When selecting "64 kbps", select "OFF" for "Mic
mode" on the "Audio" tab. (
☞ page 26)
• When "64 kbps" is selected, it is impossible to carry
out the live-transmission of JPEG images and the
FTP periodic transmission simultaneously.