Panasonic AJ-SD965 - Manual (Page 24)

24
Manual editing
1
Select the editing mode.
ASSEMBLE:
Assemble (frame-to-frame continuity) editing is
performed in this mode.
INSERT:
Insert editing is performed in this mode.
2
Select the channels to be edited.
For insert editing, press the buttons corresponding
to the channels to be edited so that their lamps
light.
3
Press the PLAY button.
4
While monitoring the TV monitor, search the
position (IN point) where the editing is to be started,
and press the PLAY and EDIT buttons together at
this position.
5
Similarly, while monitoring the TV monitor, search
the position (OUT point) where the editing is to be
terminated, and press the PLAY or STOP button at
this position.The unit will change to STOP or PLAY
mode and editing will stop.
Preroll
1
Press the PREROLL button.
The VTR now performs the preroll operation.
O
If the edit IN point has been registered, the tape
is rewound from the edit IN point for the period of
time which was set by setup menu No. 000 (P-
ROLL TIME), and it then stops.
O
If the edit IN point has not been registered, the
tape is rewound from the position where the
button was pressed for the period of time which
was set by setup menu item No.000 (P-ROLL
TIME), and it then stops.
<Notes>
O
The time code or CTL must be continuously
recorded on the tape between the edit IN point and
preroll point.
O When the IN point has not been registered, it is
possible to select whether to register the IN point
and proceed with the preroll or proceed with the
preroll without registering the IN point using setup
menu No. 313 (AUTO ENTRY).