Panasonic AJ-SD965 - Manual (Page 39)

39
Setup menus
(continued)
The underlined items indicates the initial setting.
SYSTEM menu
No./Item Description
18
SYS H OFFSET
System phase adjustment.
0000 –3 : –13.4 µsec
0001 –2 : –8.96 µsec
0002 –1 : –4.52 µsec
0003 0 : 0 sec
0004 1 : +4.52 µsec
0005 2 : +8.96 µsec
0006 3 : +13.4 µsec
<Note>
Factory settings will remain unchanged even if
an attempt is
19
SYS SC/H
This sets whether the system phase is to be
adjusted by the unit or from the external
encoder remote controller.
0000 REMOTE :
The system phase is adjusted from the
external encoder remote controller.
0001 LOCAL :
The system phase is adjusted by the unit.
<Note>
The setting of this menu item has no effect when
the ENC CONTROL switch is at the LOCAL
setting.
30
BRIGHT
This adjusts the brightness of the LCD
monitor on the front panel.
0000 –7
: :
0007 0
: :
0014 7
<Note>
If setting operation is performed, the setting
value does not return to factory (default) setting.
31
CONTRAST
This adjusts the contrast of the LCD monitor
on the front panel.
0000 –7
: :
0007 0
: :
0014 7
<Note>
If setting operation is performed, the setting
value does not return to factory (default) setting.
No./Item Description
40
MENU LOCK
This selects whether the system file lock
mode is to be engaged or released.
0000 OFF : The lock is released (file data
can be changed).
0001 ON : The lock is engaged (file data
cannot be changed).
<Note>
Setup menu No. 00 (WFM SEL) can be changed
at any time regardless of the setting selected for
this menu item.
Video output signal adjustments
The video output signals are adjusted using combinations of the ENC CONTROL switch position and SYSTEM
menu item No.19 (SYS SC/H) setting.
These adjustments can be used for analog component, analog composite and SDI signal output.
A control matrix of the adjustments is shown below.
Setting
ENC CONTROL
switch position
LOCAL
REMOTE
LOCAL
LOCAL
Unit
Unit
Unit
External encoder remote
controller External encoder remote controller
REMOTE
REMOTE
SYSTEM menu item
19: SYS SC/H SYSTEM menu item
11: SYS SC COAR.
12: SYS SC FINE
13: SYS H Bottom of front panel
VIDEO LEVEL
CHROMA LEVEL
SET UP/BLC
HUE/CHROMA PH
Item adjusted