Panasonic CF-18 - Manual (Page 105)

105
List of Error Codes
When turning on the computer, if one of the following error codes or messages is displayed,
follow the instructions shown below.
If the problem persists, or if the error code or message displayed is not shown here, contact
Panasonic Technical Support.
Error Code/Message Action
0212: Keyboard error If an external keyboard is connected, disconnect this
device.
0251: System CMOS checksum
bad - Default configuration used An error has occurred in the memory that stores the
Setup Utility settings. This error occurs when the
memory content is changed through some inadvertent
operation by a program or other function.
Run the Setup Utility and load the default values,
then change the settings to the appropriate values as
needed. (
page 88 )
If the problem persists, the internal clock battery may
need to be replaced. Contact Panasonic Technical
Support.
0271: Check date and time
settings The data and time setting are incorrect.
Run the Setup Utility and set the date and time
correctly. (
page 91 )
If the problem persists, the internal clock battery may
need to be replaced. Contact Panasonic Technical
Support.
0280: Previous boot incomplete -
Default configuration used Startup has failed repeatedly, so the Setup Utility
settings have been returned to their default values, and
the computer has been restarted.
Run the Setup Utility and load the default values,
then change the settings to the appropriate values as
needed. (
page 88 )
0613: Serial Port *1 configuration
changed
0614: Serial Port *1 config. error -
device disabled
*1 The port name, such as A or B,
is displayed, indicating the
conflicting ports.
I/O address and IRQ settings are in conflict.
Run the Setup Utility and change the settings in
[Advanced] menu so there is no port conflicts.