Panasonic CF-18 - Manual (Page 74)

74
Modem
CAUTION
Do not use the PBX internal phone lines installed in company offices. Doing so may
lead to a fire or electric shock.
It is not possible to connect the modem to any of the following lines.
• Internal home phones
• Intercoms
Be sure to connect the modem telephone cable into the modem port, not into the LAN
port.
The modem may be damaged by sudden high voltage surges, as may occur in the
event of a lightning strike. We recommend use of a surge protector.
1
Connect the computer and the telephone jack (A) using a modem
telephone cable (included)(B).
Open the modem cover, position the cable so that the tab (C) matches the port ( ),
and insert the cable until you hear a "click".
2
Change the settings as necessary.
A Select [Edit] in [start] - [Control Panel] - [Printers and Other Hardware] -
[Phone and Modem Options] - [Dialing Rules], then select the location from
which you will be dialing in [Country/region].
B Input the necessary information (items such as the area code, dialing rules,
etc.), select [OK], then select [OK].
NOTE
Do not enter either the standby or hibernation mode during communications.
To remove the cable, pull out while pressing down on the tab.
<Modem-on-Hold function>
The modem of this computer has Modem-on-Hold function, which allows you to
receive an incoming call and stay connected to the internet (Call-Waiting service from
your phone company is required. Your ISP must also support V.92). To use this
function, select on the taskbar and make settings.
Connecting the Internal Modem with a Telephone Jack