Perle Systems 5500208-41 - Manual (Page 32)

Configuring Users
32 IOLAN DS1/TS2 CLI Reference Guide, Version 4.1
Version
Description Displays firmware version and build.
User Level Normal, Admin
Syntax
Configuring Users
Add User
Description Adds a user. For units with 4 or less serial ports, you can configure up to 4 users. For
units with 8 or more serial ports, the maximum number of users which can be added is
48. This is in addition to the admin user.
User Level Admin
Syntax
Option
<username>
The name of the user, without spaces. When you finish the command and press Enter,
you will be prompted to enter and re-enter a password for the user.
Delete User
Description Deletes a user.
User Level Admin
Syntax
Option
<config_user>
You can see a list of users that can be deleted by typing
delete user ? . You can not
delete the admin user.
Set Default User
escape
Defines the escape character. Returns you to the command line mode. This value is in
hexadecimal with a default value of 1d (ASCII value GS ).
version
add user <username>
delete user <config_user>
Description Configures the Default User. When adding a new user, the profile of the default user
will be used to assign the values of the various parameters of the new user. (CLI and
menu only).
User Level Admin
Syntax
set default user [host-ip None|<ip_address>|<config_host>]
[hotkey-prefix <00-7f>] [idle-timer <0-4294967>]
[language english|customlang]
[level admin|normal|restricted|menu]
[line-access readin|readwrite [on|off]|<line(s)> [0]]
[port tcp-clear|telnet <tcp_port>]
[service dsprompt|telnet|tcp-clear] [sess-timer <0-4294967>]
Options host-ip
For outbound User Services such as Telnet , this is the target host name or IP address. If
no IP address is specified, the Host IP value in the Default User configuration will be
used. The default is 0.0.0.0 . or None.