Perle Systems 5500208-41 - Manual (Page 39)

IOLAN DS1/TS2 CLI Reference Guide, Version 4.1 39
Line Commands
Chapter 4
4
This chapter defines all the CLI commands associated with configuring the IOLAN’s line parameters.
1-Port vs. 2-Port Line Commands
If you are using a DS1 IOLAN, the admin user does not have the option of using the number or all
(*) options in the line commands, as there is only one line. In an TS2 IOLAN, the admin user must
specify
. (current line), < number > (line number), or * (sets value for all lines) when configuring
lines.
Line Commands
Set Line
Description Configures line parameters.
User Level Admin
Syntax
set line .|<number>|* [data-bits 5|6|7|8] [break on|off]
[break-delay <0-65535>] [break-length <0-65535>]
[connection-method dial-in|dial-out|dial-in-out|direct-connect]
[idle-timer <0-4294967>] [line-name <name>]
[modem-name <config_modem>] [pages 1|2|3|4|5|6|7]
[parity none|even|odd|mark|space] [phone-number <phone_number>]
[rev-sess-security on|off] [send-name on|off] [session-strings
|delay <0-65535> |initiate <text> |terminate <text>] [sess-timer
<0-4294967>]
[stop-bits 1|2|1.5] [termtype wyse60|vt100|ansi|dumb|tvi925|
ibm3151te|vt320|hp700|term1|term2|term3]
Admin set line ... flowin on|off] [flowout on|off] [hotkey-prefix
<00-7f>] [data-logging on|off]
[initiate-connection any-char|specific-char <hex_value>]
[initial cli|menu] [keepalive on|off] [lock on|off]
[mode enabled|disabled][motd on|off] [reset on|off]
[dial-timeout <number>] [dial-retries <number>]
[single-character on|off] [user <name>] [nouser]
[internet-address <IPv4_address>] [user <config_user>]