Planet Technology DVR-860 - Manual (Page 51)

LICENSED SOFTWARE AP
-45-
h. System Config : Press this button to enter the setting page of the licensed software AP.
i. Number of Online Users
j. CH 1 ~ 4 , there will show CH 1 ~ 8, if you connect to a DVR-860.
k. Change Display Mode
l. Search : Press this button to enter the DVR search menu.
m. Record
n. Stop / Fast Rewind / Fast Forward / Pause / Slow Playback / Play
o. ＋
p. －
q. Digital Zoom : Digital zoom in/out
r. Set :
Press this button to change the position of the channel display.
Press “UP”, “DOWN”, “LEFT”, “RIGHT” buttons to select the channel you would like to change.
Press “＋” or “－” select the channel you would like to show.
Press “Enter
” button to confirm the setting.
s. Sequence :
Press this button to enter the call monitor function, and press again to exit from the call monitor mode. When any
motion is detected, the monitor will switch to the channel which is motion-triggered.
t. Enter : Press this button to confirm the settings or enter your selection.
u. PTZ Control On / Off:
When the PTZ control is turned on, users could select the PTZ device, and press “OK” button to enter the PTZ
control AP screen. (Press “ESC” to exit from the PTZ control AP screen and return to the DVR control AP screen)
v. Menu / Up / Down / Left / Right :
Press button to enter the menu / to confirm the selection and return to the upper menu / exit the menu
mode. (Via software AP or IE browser, you can remote login to the DVR, but if the user name and password that
you used is not the supervisor level, you are not allowed using this function. For detailed user name and
password setting, please refer to “(1) Account” in the section “7.5.4 General” at page 58.)
Press buttons to move the cursor and make the selection.
w. Search DVR Video Data :
Press this button to show the following window and set data search criteria. The video data found will be played
in the AP view.
x. Turbo ON/ OFF :
To speed up menu selection or the control of the PTZ camera under the software AP, users can activate TURBO
function by clicking this button. Users are allowed to change the turbo steps from 1 to 30.
Ex: If users activate TURBO function and set the value of the turbo step as 3, one mouse-click will function as
clicking 3 times when users press one of the button up/down/left/right.