Perle Systems RPS1630 - Manual (Page 10)

2-2
RPS Series: Remote Power Switches - User's Guide
➂ Bus "A" Switched Plugs and Plug Indicators: AC Outlets that can be
switched On, Off or rebooted in response to user commands.
• RPS820: Four 208-240 VAC, IEC-320-C13 Outlets with indicator
lights. 10 Amps Total Load.
• RPS830: Four 100-120 VAC, NEMA 5-15 Outlets with indicator
lights. 15 Amps Total Load.
➃ Bus "B" Switched Plugs and Plug Indicators: AC Outlets that can be
switched On, Off or rebooted in response to user commands. Includes
same components listed for Circuit "A" in item 3 above.
➄ Default Button: This button can be used to either reset the unit to
default parameters or manually toggle all plugs On or Off:
• Default Parameters: With the Main Power switch set in the Off
position, press and hold the Default Button, then set the Main Power
switch in the On position and release the Default Button. All menu
defined parameters will be reset to default values.
• Manual Plug Toggle: Press the Default Button and hold it down for
three seconds. All RPS power outlets will be toggled On or Off.
Note: If desired, the Default Button’s manual plug control
capabilities can also be disabled as described in Section 5.3.1.
➅ Unit Status Indicators: Two LED Indicators which function as
follows:
• ON: Lights when power is applied to the RPS Unit.
• RDY: Flashes continuously when the RPS is ready to recieve
commands.
➆ Network Port and Activity Indicator: An RJ45 Ethernet Port
for connection to your TCP/IP network. The default IP Address is
192.168.168.168, for more information, please refer to Section 5.3.4.
The Activity Indicator flashes to indicate activity at the Network Port.
➇ Main Power Switch: Applies power to the RPS Unit. This switch must
be "On" in order for the RPS to function. Note that this switch is not
used to set the On/Off status of the switched outlets.
➈ COM / RS232 Port: A DB9, RS232 serial port (DTE), for connection
to a local terminal or external modem, as described in Section 4.3.