Perle Systems RPS1630 - Manual (Page 52)

6-4
RPS Series: Remote Power Switches - User's Guide
6.2.2. Switching and Reboot Commands - Text Interface
These commands can be used to switch plugs On/Off, reboot plugs or set plugs
to their user-defined Power Up Default values. Plugs may be specified by
name or number.
Notes:
• Wait for the command prompt to appear before entering
additional commands. The prompt will not reappear until the
previous command is complete.
• Commands are not case sensitive. All commands are invoked
by pressing [Enter].
• Users who log into command mode with a Plug password, will
only be allowed to issue commands to the plugs allowed by
that password.
• If command confirmation is enabled, the RPS will display the
Status Screen after commands are successfully completed.
• When switching or reboot operations are initiated, Boot/
Sequence Delay times will be applied as described in
Section 5.3.3.2.
Remote Power Switch v1.43s Site ID: (undefined)
Display Configuration
/H Display Help Screen /G View/Set General Parameters
/S Display Plug Status /P [n] View/Set Plug Parameters
/SN Display Network Status /C View/Set Serial Parameters
/N View/Set Network Parameters
Control /T View/set Telnet Parameters
/D Set Plugs to Default /W View/Set Web Server
/Boot <n> Boot Plug n /E Save Parameters
/On <n> Turn On Plug n /R Recall Parameters
/Off <n> Turn Off Plug n /DL Download Parameters to File
/X Exit/Disconnect
Utilities
+------------------------------------+ /I Reset Network Interface
| [n] = optional plug name or number | /U Upgrade Firmware
| <n> = required plug name or number |
| n+n or n n = plug n and plug n |
| n:n = plug n through plug n |
| * = all plugs |
| ,y = bypass “Sure? (y/n)” |
+------------------------------------+
RPS>
Figure 6.3: The RPS Help Screen - Text Interface