Panasonic TX-86PW100A - Manual (Page 3)

3
Getting Started
Connect the Aerial
The RF (Aerial) Input impedance of this television is 75
?
. If your aerial lead is 300
?
ribbon (two wires separated
by a flat plastic strip) you will require a 300
?
/75
?
Balun in order to connect your aerial to the television.
For your safety any external aerial should be installed by a reputable qualified installer and should comply with
Australian Standard AS1417.1.
In New Zealand the installation should comply with International Standard IEC597-1.1.
Connect the Power Plug
This television is designed for the Australian Standard Mains Voltage of 240V 50Hz and the New Zealand
Standard Mains Voltage of 230V 50Hz.
NOTE:
If the television is not going to be used for an extended period, remove the power plug from the wall outlet.
Turn on the Television
Push the Power Switch to turn the television
ON. Sit back and enjoy your new Panasonic
television.
To Antenna
TX-76PW50A
TX-86PW100A & TX-76PW100A
300 / 75
Balun
? ?
300
Cable
?
???
Cable
RF
Input
PCM/AC-3 DIGITAL AUDIO INPUT
EXT
FRONT
OPTICAL
AUDIO - OUT MONITOR OUT AV1 IN
S-VIDEO
VIDEO
L L
R R
C W
FRONT REAR
CENTRE SUB WOOFER
AV2 IN AV4 IN
COAXIAL
REAR
L
L
R
R
AUDIO
L
R
AUDIO
L
R
MONO MONO MONO
VIDEO Y Y
P B P B
P R P R
DVD Y - P - P B R DVD Y - P - P B R
Manufactured under license
from Dolby Laboratories.
“Dolby” “Pro Logic” and the
double - D symbol are trademarks
of Dolby Laboratories.
Confidential Unpublished Works
© 1992 - 1997 Dolby Laboratories Inc.
All Rights Reserved.
MONITOR OUT AV1 IN
S-VIDEO
VIDEO
AV2 IN AV4 IN
AUDIO
L
R
AUDIO
L
R
MONO MONO MONO
VIDEO Y Y
P B P B
P R P R
DVD Y - P - P B R DVD Y - P - P B R